Insert the long legs of a six-pin ICSP male header into the smaller connector on the USBtinyISP.

Be sure the USBtinyISP's jumper is in place. Plug in your FLORA over USB and also connect your USBtinyISP to your computer over USB.

Connect the pins to FLORA as shown, using diagonal pressure to make good contact between the legs of the header and the ISCP pads on FLORA.

flora_Screen_Shot_2014-06-30_at_3.49.34_PM.png

Select Adafruit Flora from the Boards menu.

flora_Screen_Shot_2014-06-30_at_3.49.41_PM.png

Select USBtinyISP from the Programmer menu.

flora_Screen_Shot_2014-06-30_at_3.49.46_PM.png

Hold the ICSP connector in place and click Burn Bootloader from the Tools menu. It will take a while, even longer than a minute. Sit tight and don't let go until the status reads Done burning bootloader. Congrats, you're done!

This guide was first published on Jul 08, 2014. It was last updated on Jun 30, 2014.

This page (Reprogram FLORA over ICSP) was last updated on Jun 30, 2014.

Text editor powered by tinymce.

Search