Cut a heel-shaped piece of velostat and tape a loop of conductive thread to it, with a long (at least 18 inches) tail sticking out to one side.

Cut another piece for the other shoe and repeat.
Flip the pieces of velostat over and tape another loop of conductive thread . The tails should be on the same side, but at least two inches apart.

This guide was first published on Aug 28, 2013. It was last updated on May 10, 2013.

This page (Make Velostat Step Sensors) was last updated on Aug 20, 2013.

Text editor powered by tinymce.