3D Printed Mask Clamp Parts

STL files for 3D printing are oriented to print "as-is" on FDM style machines. Original design source may be downloaded using the links below.

  • mask-clamp.stl
  • mask-clamp-fill.stl

3D Printed Magnet Ear Savers Parts

STL files for 3D printing are oriented to print "as-is" on FDM style machines. Original design source may be downloaded using the links below.

  • magnet-ear-clip-right.stl
  • magnet-ear-clip.stl

Support Material for Magnet-ear-clip-right.stl

The Right Magnet Ear Clip requires support material. Enable supports in the slicing software to generate scaffolding to support overhanging geometry. Use the following recommended settings:

  • Support Placement: Everywhere
  • Support Overhang Angle: 80
  • Support Pattern: ZigZag
  • Support Density: 4%
  • Enable Support Brim: No
  • Support Z Distance: 0.22mm
  • Enable Support Interface: No

This guide was first published on Jun 23, 2020. It was last updated on Jun 23, 2020.

This page (3D Printing) was last updated on Jun 23, 2020.

Text editor powered by tinymce.