Mount STEMMA sensors

 

The bottom features slots so you can use M2.5 hardware to secure STEMMA QT sensors if you wish.

You can fit up to two boards and secure them using hex nuts.

Using the stacking headers, you could stack multiple sensor on top of each other!

A small Lipo battery is able to fit in-between the built-in standoffs with the cable routed thru the side.

 

The Feather press fits into the case. The two covers just snap fit over the top.

The STEMMA QT connector is accessible so you can daisy chain your sensors and make a portable IoT project!

This guide was first published on Jan 25, 2022. It was last updated on 2022-01-25 11:50:13 -0500.

This page (Assemble) was last updated on May 24, 2022.

Text editor powered by tinymce.