3D print a Stemma case for the Adafruit TFT Feather with ESP32-S2.

This dev board features a 1.14 inch display with a Lipo battery charging circuit and battery monitor.

It's has the ESP32-S2 mini module which works with both Arduino or CircuitPython.

We designed and 3D Printed a snap fit case to make a little compact IoT project.

You can easily add STEMMA QT breakouts like temperature and humidity sensors.

The two buttons on the front are accessible so you can quickly reboot or get into the bootloader.

The STEMMA QT connector is also accessible, so you can daisy chain your sensors and make a portable IoT project.

 

You can 3D print the parts without any support material using your favorite filament.

The bottom features slots so you can use M2.5 hardware to secure STEMMA QT sensors.

You can fit up to two boards and secure them using hex nuts.

A small Lipo battery is able to fit in between the built-in standoffs with the cable routed through the side.

The Feather press fits into the case and the two covers just snap fit over the top.

 

Parts

Adafruit ESP32-S2 TFT Feather powered on by a USB- C power source displaying the product tittle in a red, yellow, green, white and blue.
We've got a new machine here at Adafruit, it can uncover your deepest desires. Don't believe me? I'll turn it on right now to prove it to you! What, you want unlimited...
Out of Stock
Angled shot of a rectangular lipo battery with a 2-pin JST connector. The battery specs are listed on the body: 3.7V 250mAh.
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
Out of Stock
Angled of of JST SH 4-Pin Cable.
This 4-wire cable is 50mm / 1.9" long and fitted with JST SH female 4-pin connectors on both ends. Compared with the chunkier JST PH these are 1mm pitch instead of 2mm, but...
Out of Stock
Black Nylon Screw and Stand-off Set with M2.5 Threads, kit box
Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker...
$16.95
In Stock
Angled shot of a USB key-shaped PCB with a sensor board stacked on top via black nylon screws.
 Here is the perfect hardware kit to make a RP2040 QT Trinkey into any kind of USB-connected smart sensor with a...
$1.50
In Stock

This guide was first published on Jan 25, 2022. It was last updated on Mar 08, 2024.

This page (Overview) was last updated on Mar 08, 2024.

Text editor powered by tinymce.