Choose Headers
Decide which headers will be needed for your project. The Feather RP2040 Scorpio ships with the following headers:
- 2x 1x16 male straight headers
- 1x 2x8 male straight headers
- 1x 2x8 male right-angled headers
Installing Headers
The case supports headers installed onto the top side of the Feather RP2040 Scorpio.
Install Feather RP2040 Scorpio
Insert the Feather at an angle so the PCB slides underneath the clips.
External wire can be fed through the bottom slot of the case such as voltage and ground connections.
Align Mounting Holes
Place the PCB down so it fits flush with the built-in standoffs. Adjust the PCB so the mounting holes are lined up.
Install Screws
Insert two M2.5 x 10mm long screws through the bottom of the case.
There's a slot down the middle of the case back that can be used for external wires.
Secure Feather
Insert and fasten 2x M2.5 hex nuts onto the threads of the screws.
Make sure the hex nuts do not cover the on-board LEDs on the Feather.
