Cut, splice and tin three pieces of wire.

Solder a wire to each of the three legs of the potentiometer.

Repeat this process for the remaining three potentiometers.

Solder the potentiometer ground wires to the GND rail on the FeatherWing Proto.

Solder the poteniomters positive wires to the 3.3V rail on the FeatherWing Proto.

Solder potentiometer 0 wiper wire to pin A0 on the FeatherWing Proto.

Solder potentiometers 1, 2 and 3 wipers to pins A1, A2 and A3 respectively on the FeatherWing Proto.

Solder the ground pins on the buttons together. Then, solder wires to the LED anode and button output pins. The LED anode and LED ground are marked with + and - symbols.

Insert both buttons with their wires soldered into the acrylic plate.

Solder the buttons' wires to the FeatherWing Proto:

• Button GND wires to FeatherWing Proto GND rail
• Button 1 output to FeatherWing Proto D5
• Button 1 LED to FeatherWing Proto D6
• Button 2 output to FeatherWing Proto D9
• Button 2 LED to FeatherWing Proto D10