If you are using the Adafruit MEMENTO Camera Enclosure Kit with this guide, use the included JST cable to connect the Adafruit MEMENTO Camera LED Ring Front Plate 3-pin JST Connector and the 3-pin JST connector labeled A1 on the MEMENTO.
If you do not have the MEMENTO Camera Enclosure Kit (or if it is out of stock), you can build your own ring light for the MEMENTO using the following parts:
What is better than smart RGB LEDs? Smart RGB+White LEDs! These NeoPixel rings now have 4 LEDs in them (red, green, blue and white) for excellent lighting effects. Round and...
$9.50
In Stock
This cable is a little over 100mm / 4" long and fitted with JST-PH 3-pin connectors on either end. We dig the solid and compact nature of these connectors and the...
$0.75
In Stock
You must cut the JST PH 3-pin cable in half using a wire cutter. Using a soldering iron, make the following connections between the cable and the NeoPixel ring.
- JST VCC (red wire) to NeoPixel PWR
- JST GND (black wire) to NeoPixel GND
- JST Data (white wire) to NeoPixel Data In
Then, plug the cable into the MEMENTO's A1 JST port.
Page last edited March 08, 2024
Text editor powered by tinymce.
