Wiring the Servo
For wiring the Micro Servo with 3-pin JST PH, connect the servo's 3-PIN JST connector to the receptacle labeled A1 on the MEMENTO.
Wiring the NeoPixel Ring using the MEMENTO Camera Enclosure Kit
If you are using the Adafruit MEMENTO Camera Enclosure Kit with this guide, use the included JST cable to connect the Adafruit MEMENTO Camera LED Ring Front Plate 3-pin JST Connector and the 3-pin JST connector labeled A0 on the MEMENTO.
Wiring the NeoPixel Ring without the MEMENTO Camera Enclosure Kit
If you do not have the MEMENTO Camera Enclosure Kit (or if it is out of stock), you can build your ring light for the MEMENTO using the following parts:
Use socket and plug Jumper wires to easily connect the Neopixel ring when mounting to the robot enclosure.
Cut the JST PH 3-pin cable in half using a wire cutter. Using a soldering iron, make the following connections between the cable and the NeoPixel ring:
Make the following connections between the MEMENTO and the NeoPixel ring:
- MEMENTO A0 VCC to NeoPixel ring PWR
- MEMENTO A0 GND to NeoPixel ring GND
- MEMENTO A0 Data to NeoPixel ring data IN
Text editor powered by tinymce.
