Mount LED ring
Thread the jumper wires through the cut outs in the circular mount. The LED ring PCB press fits inside the body part.
Frame assembly
Use four M3x6mm to connect the servo holder part to the frame part.
The frame mounts to the MOMENTO board with three M3x20mm long screws.
Mount Servo
Use two screws to mount the servo to the holder.
Attach frame assembly
The frame aligns and mounts to the three mounts on the MEMENTO PCB.
Connect JST cables
Connect the servo and LED ring JST cables to the ports on the MEMENTO.
Mount frame assembly
The frame assembly mounts to the standoffs on the body print.
Connect jumper wires
The LED jumper socket and pin wires connect and then are tucked inside the body.
Attach back body
Align the back body print with the tab holes on the sides.
Base assemble
The base plate houses the servo horn and magnet clips.
Press fit the included servo horn into the cutout on the base plate.
Align the magnet bar to the cutouts on the rectangular base plate. The magnet bar part press fits into place so the magnets are flush with the cutouts.
Mount with magnets
The magnets are strong enough to hold the robot on metal surfaces. A ferromagnetic bar is used to help mount to a shoulder.
Tripod attachment
The tripod attachment uses the included servo horn and 3/8 to 1/4-20 tripod thread.
Text editor powered by tinymce.
