This project requires some assembly (like the music box) for you to get really good performance out of it. 

Servo Wiring

We are going to wire the servo such that the longer wires in your breadboard wiring bundle are used. We want to mount the Servo on 

Base Assembly

Take a piece of tape and fold it into itself (or roll it up).

Then, place it on the mounting plate. Press down so it retains a firm grip (servos move really forcefully).

Take a twist-tie (like the ones you can get at your local supermarket) or a zip-tie and affix the Laser Pointer to the horn of the servo. We like using zip-ties and twist-ties because they're super inexpensive and non-permanent.