Feather Headers

Use a 1x12 and 1x16 male header pins for the Feather ESP32-S3.

A breadboard can help to keep the headers straight while soldering.

Solder all of the male header pins to the Feather ESP32-S3.

Install Feather to TFT Display

Orient the Feather with the 3.5in TFT FeatherWing so the pins line up properly.

Firmly press the pins into the TFT FeatherWing's socket headers.

Hardware

Use the following hardware to secure the 3.5in TFT FeahterWing to the 3D printed stand.

• 4x M2.5 x 6mm long screws
• 4x M2.5 x 6mm long M-F hex standoffs
• 4x M2.5 hex nuts

Install Hardware to TFT Display

Insert the M2.5 x 6mm long screws through the four mounting tabs on the TFT Display.

Insert and fasten the four M2.5 standoffs onto the screws.

Repeat the hardware installation for the four mounting tabs.

Install TFT to Stand

Orient the TFT display with the 3D printed stand so the USB-C port is pointing in the correct direction.

Press the screws from the standoffs through the four mounting holes on the 3D printed stand.

Secure TFT to Stand

Insert and fasten the M2.5 hex nuts onto the standoffs to secure the TFT display to the 3D printed stand.

USB Power

Connect the Feather ESP32-S3 to a 5V 1A power supply to power on the device.

Congratulations on your build!