Cut and strip the two wires from the speaker.

Secure the speaker wires into the terminal block on the amp.

• Speaker negative to amp terminal block - (black wire)
• Speaker positive to amp terminal block + (red wire)

Attach the amp to its standoffs with two M2.5 screws.

Attach the mic to its standoffs with two M2.5 screws.

Insert the battery into its clip. Make sure the battery wires are pointing towards the amp.

Attach the w.FL connector to the Feather. The connector clicks onto the port on the Feather.

Secure the Feather to its standoffs. Use M2.5 screws for the mounting holes closest to the three buttons and M2 screws for the mounting holes closest to the reset button.

Plug in the battery to the Feather after it is mounted.

Remove the adhesive from the front of the speaker. Insert it into the speaker mount in the case.

Insert the RP-SMA plug into the top mounting hole on the case. Secure it with its included nuts.

Place the lid onto the case. Use four M3 screws to secure it.

Attach the external antenna to the RP-SMA plug.