Hardware — image 1 of 4

microcontrollers_CloudThermometer_bb.png
details

Assembly

For the CC3000, connect it to the Arduino in the same way as this CC3000 tutorial:
  • Arduino 5V to CC3000 VIN
  • Arduino ground to CC3000 ground
  • Arduino digital pin 13 to CC3000 CLK
  • Arduino digital pin 12 to CC3000 MISO
  • Arduino digital pin 11 to CC3000 MOSI
  • Arduino digital pin 10 to CC3000 CS
  • Arduino digital pin 5 to CC3000 VBEN
  • Arduino digital pin 3 to CC3000 IRQ

Next, connect one end of the 10K resistor to 5V power on the Arduino, and the other end to one lead from the thermistor probe. Connect the remaining thermistor lead to ground on the Arduino. Finally connect a wire in between the resistor and thermistor lead connection, and run the wire to an analog input on your Arduino (like analog input 0).

If you don't have a 2.5mm jack for your probe thermometer, you can connect alligator clips to each metal terminal on the plug. See the photo on the left for an example alligator clip connection. You can also see an example of the hardware I built using an Arduino Nano and CC3000 breakout.
Back

Search