Electronics Assembly — image 1 of 1

details

Slip a small piece of clear heat shrink onto the LED strip before soldering and move it down the strip until it's out of your way.

Connect the wires to your LED strip, making sure you're soldering to the IN end (the arrows printed on the strip should be pointing away from your solder joints). Connect red to 5v, black to G, and white to 32.

Plug in your microcontroller and verify that the lights come on. If you've loaded WLED they will come on in all yellow, or if you haven't done that yet they'll come on in rainbow. Either way, make sure your strip comes on before you seal it up.

To seal the strip, fill the heat shrink with a little hot glue to pot the wires in plastic. This way they're much less likely to pull off or break while you're assembling the project.

Back

Search