Hardware — image 2 of 2

gaming_capsule-closed.jpg
details

The interior of the tube is tapered slightly, and it was necessary to sand about 1/8" width from the motor driver to make it fit down in the narrow end. Best done on the edge with the motor connections, as the other edge sits close to a PCB trace.

The vibration motor is taped to the haptic controller board, and some craft foam is inserted alongside to keep these firmly pressed against the tube body to better conduct the vibration.

A 100 mm STEMMA cable gives enough slack that the motor and controller can stay put while other parts are removable to access the power switch or for charging and uploading code.

Once capped, the whole circuit is well protected from the elements!

Back

Search