Add to Your Wearables — image 3 of 4
If you want to hide the excess wires inside the hat, mark two small holes on either side of where you want to place the Gemma LED. Leave enough room so the wires don't have to bend straight down, to avoid straining and possibly breaking them.
Then carefully cut a slit for the light wire. (A ceramic craft knife is safe enough for kids to do this themselves, with adult help.) Thread the end of the light wire through the slit.
For the battery pack wire, cut a small flap to fit the JST plug through. Press the flap closed around the wires when you're done.
Then mark where you want the lights to come out, and cut a slit where the crown meets the brim. Bring the light wire out through that hole and wrap it around the hat.
Finally, attach the battery pack to the top of the hat. (Tape will work temporarily, but for permanent use, put adhesive under the battery pack so you can open it to replace the batteries.)