3D Printing — image 1 of 1

leds_Screenshot_(72).png
details

Slicing

Supports were used on the bottom part, but not on the top.

The parts were sliced using CURA using the slice settings below.

  • PLA filament 210c extruder
  • 0.1mm layer height
  • 30% infill infill
  • 60mm/s print speed

The supports for the bottom half were set to have an 80-degree support overhang angle to avoid them being used in the hole that connects the Circuit Playground, as it wasn't necessary. However, that may depend on the printer being used.

Back

Search