Build the Sensor Circuit — image 3 of 10

feather_IMG_3240_2k.jpg
details

To connect the sensor bar to the Crickit sensor inputs and power, we'll make some cable sets and add removable header connectors.

 

First, peel off a five wire section of the raw male/male jumper wires with the color set as shown.


Then, push the cable ends on either side into their own 5-pin dupont connector.

 

Repeat this with a red-brown pair of male/female jumper wire, and add 2-pin dupont connectors to it.

 

Next, use diagonal cutters to clip off a 5-pin section of the right-angled female header, and a 2-pin section of the right-angled male header. We'll use different polarities here to reduce the chance of mis-plugging something.

 

Solder the 5-pin header as shown.

 

Jumper a column to power rail and ground as shown, then add the 2-pin male header as shown, this is where the power will plug in. It is important to plug these in correctly! The color coded jumper wire helps.

Back

Search