Build the Sensor Circuit — image 2 of 10
To connect the sensor bar to the Crickit sensor inputs and power, we'll make some cable sets and add removable header connectors.
First, peel off a five wire section of the raw male/male jumper wires with the color set as shown.
Then, push the cable ends on either side into their own 5-pin dupont connector.
Repeat this with a red-brown pair of male/female jumper wire, and add 2-pin dupont connectors to it.
Next, use diagonal cutters to clip off a 5-pin section of the right-angled female header, and a 2-pin section of the right-angled male header. We'll use different polarities here to reduce the chance of mis-plugging something.
Solder the 5-pin header as shown.
Jumper a column to power rail and ground as shown, then add the 2-pin male header as shown, this is where the power will plug in. It is important to plug these in correctly! The color coded jumper wire helps.