Wiring — image 1 of 1

3d_printing_speaker-wires-solder.jpg
details

Wire Button LED to Power

I didn't think speakers needed specific polarity, but there was a positive and negative symbol printed on the pads, so I followed them accordingly.

OK, now we have our speakers ready to wire into the amp. Before we do however, we'll need to assemble the 3D printed parts. This project is a bit special, because we can't wire all of the components before mounting them to some of the 3D printed parts. This is because if we did, we wouldn't be able to fit the components through the 3D printed rod. So if your prop has similar features, you'll need to think about that.

Back

Search