Explore
Groups to get your gears turning
Six wires need to run between the Pro Trinket and Sound Board. Two are for power, four for various signals. Using either board as a measuring stick, cut these wires to about 2X the board’s length. Strip a little insulation from one end and tin each wire.
The two power wires connection to the + and – pads on the underside of the Sound Board. Tin these pads first with a little solder, then hold the previously-tinned wire in place and re-melt the solder to join the two. The solder joints need to be smooth and shiny, not beaded up on the surface.
The other four wires connect to TX, RX, Act and Rst.