Soldering — image 3 of 3

gaming_amp3.jpg
details

Next we’ll add a few wires to the tiny amplifier board…but the Sound Board is borrowed as a measuring stick of sorts. One board will be stacked atop the other, so we know any connections between the two won’t exceed this length.

Cut four wires just a little longer than the Sound Board. Two are for power, two for audio. Then cut two wires about 4 inches long, for the speaker.

Strip a small bit of insulation from just one end and tin each wire to prevent fraying.

The four short wires go to Vin and GND (for power) and A+ and A– (audio input). The two long wires go to the 4–8Ω audio output (do not install the screw terminals, solder the wires directly).

Cut one more wire in-between these lengths. Strip, tin and solder it to the SD pin.

After the solder has cooled, trim and protruding wires from the underside of the board, and make sure any clippings end up in the trash, not in the d20. Do the same with other boards as you work through the project.

Back

Search