Soldering 101 — image 2 of 4

components_batwire2.jpg
details

Cut a couple more pieces of heat-shrink tubing, about 3/4" to 1" long. Slide these over one pair of wires (either the battery pack wires or the wires leading to the LEDs).

 

Twist the wires, solder the connections, and shrink the tubing as before.

 

One more heat shrink tip: keep the un-shrunk tube away from the connections while soldering; the hot wires will shrink the tubes prematurely. This stuff is just fraught with peril, isn’t it? But it’s so much nicer than electrical tape!

Back

Search