Board Assembly — image 1 of 1

adafruit_products_vfdtest.jpg
details

Clear off your desk and plug in the DC adapter. You should hear a beep and the display turn on and display some numbers (probably 12 00 00) If you get anything on the display you're doing great and the tube is working well. Note that it will be very dim! That is because the display is designed to be at the lowest brightness (voltage) when first built. Once its in an enclosure you can make it brighter! If the tube seems to not be working, turn off all the lights and look again.

If you're having problems, check that you have the boost converter working, that you installed all the parts including the chip and that all pins are soldered well. With the MAX6921 chip in place, the boost converter voltage will no longer be outputting 70V but will measure at around 20V, this is OK.

If you need to probe the voltage, remember not to touch the right hand side of the board. Use a nonconductive vise to hold the left side near the 5V regulator only!

Once you're done, unplug the DC jack and wait a few minutes to let the boost converter drain.

Remove the tube from the mainboard.
Back

Search