Board Assembly — image 4 of 4

adafruit_products_socketdone.jpg
details

Now place the IC socket. The socket protects the microcontroller chip and allows it to be replaced if necessary.

The socket has a U-shaped notch in one end. Make sure that this notch matches the U-shaped notch in the silkscreen, see the image to the left if you're not sure. If you end up putting the socket in backwards, don't fret. Its not essential that it is in right, but it will help you if you have to replace the chip.

You can keep the socket in place with tape or if you have long fingernails, by bending over two of the little legs to hold it in place. First solder in 2 opposite corners. Then solder the rest of the pins.

They do not need to be clipped as they are already quite short.

Back

Search