Ninjaflex 

Print a bunch of these "spool" shaped diffusers in white NinjaFlex flexible filament. The design is optimized to print with no support material.

Slicer Settings

For the best quality when printing with NinjaFlex, we recommend the following slicing settings:

  • Retraction: Off
  • Speeds: 45/50
  • Extruder Temp: 230c
  • Infill 10%
  • Raft+Support: Off
  • No Heated Bed

Each diffuser has three sew-tabs you can use to attach over a NeoPixel. Sewing them all on is quite time consuming, but we think it's worth it!

Modify Design

The original solids where created in Autodesk 123D Design. You can customize the diffusers to match your project.

This guide was first published on Jun 17, 2015. It was last updated on Jun 29, 2015.

This page (3D Printed Diffusers) was last updated on Jun 17, 2015.

Text editor powered by tinymce.