Use two power cables with ring terminals to supply 5VDC to the receiver card.
You'll be plugging 3 IDC cables into the receiver card IDC cape. The red side of the ribbon goes opposite the 'J' labels.
J1 -> Top Panel
J2 -> Input of the 4 panel chain
J3 -> Bottom Panel
Once all IDC connections are made, plug the cape into the receiver with the electrolytic capacitor towards the ethernet jacks. It's very easy to plug this in backwards :)
The top and bottom panels can still be off at this point but connect all data and power cables.
J1 -> Top Panel
J2 -> Input of the 4 panel chain
J3 -> Bottom Panel
Once all IDC connections are made, plug the cape into the receiver with the electrolytic capacitor towards the ethernet jacks. It's very easy to plug this in backwards :)
The top and bottom panels can still be off at this point but connect all data and power cables.
Page last edited September 23, 2013
Text editor powered by tinymce.
