DIY LED Video Cube by James DeVito published September 26, 2013, last edited September 26, 2013 posted in LEDs/ LED Matrices Save New Favorite × Please sign in to include this guide in your list of favorites. You will be redirected back to this guide once you sign in, and can then save this guide as one of your favorites. Download Overview Parts List LED Panel Prep Aluminum Frame Preparing the Top and Bottom Wiring Data & Power Mounting the Receiver Wiring the Receiver Power Bus Distribution Preparing the Sender Card LED Studio Software Configuration Verifying & Finishing the Cube Video! Single page Feedback? Corrections? Text View Featured Products view all 32x32 RGB LED Matrix Panel - 6mm pitch $39.95 Add to Cart Slotted Aluminum Extrusion - 20mm x 20mm - 610mm long $7.50 Add to Cart Aluminum Extrusion Double Corner Brace Support (for 20x20) $1.95 Add to Cart 4-pin AT / ATX / IDE Molex to Berg Floppy Drive Power Cable $1.95 Add to Cart Power Distribution Bus - 7 x 6mm diameter solid brass $1.95 Add to Cart Compact Switching Power Supply - Selectable Output 3-12VDC $14.95 Add to Cart 138 Beginner Project guide LED Studio Software Configuration Use the setup from the LED Video Wall tutorial, but load the receiver with the AdaCube.RCG file below. AdaCube.RCG Page last edited September 23, 2013 Text editor powered by tinymce. Preparing the Sender Card Verifying & Finishing the Cube