The 4 horizontal sides of the cube will be linked together to create one row of video data.

Fold the ribbon cable over and use a rubber band to keep it tidy and short. Use 3 of these to run data from the output to the input of each adjacent panel.

Leave the input of the panel where there is no aluminum corner brace so it will be a short run to where the receiver card is mounted.
The panels also come with power Y cables. Use two of these to power the 4 panels. Make sure to keep the proper polarity when plugging in the connectors.
Shorten the longer IDC cable to an appropriate length if needed and connect it to the input of the first panel in the chain.

This guide was first published on Sep 26, 2013. It was last updated on Sep 26, 2013.

This page (Wiring Data & Power) was last updated on Sep 23, 2013.

Text editor powered by tinymce.