This diagram uses the original Gemma but you can also use the Gemma M0 with the exact same wiring!
Follow the circuit diagram to and solder the components together using wrapping wire. Carefully measure the lengths of wire to ensure the components will have enough slack to reach the desired location in the 3d Printed model. The ray gun will require significantly more wire.
D1 > IN NeoPixel Ring GND > GND NeoPixel Ring Vout > PWR NeoPixel Ring GND > Top Right - MLX90614 3V > Bottom Right - MLX90614 D0 > Bottom Left (Include Resistor) - MLX90614 D2 > Top Left (Include Resistor) - MLX90614 JST > 3X AAA Battery Holder
You have been successfully subscribed to the Notification List for this product and will therefore receive an e-mail from us when it is back in stock!
For security reasons, an e-mail has been sent to you acknowledging your subscription. Please remember that this subscription will not result in you receiving any e-mail from us about anything other than the restocking of this item.
If, for any reason, you would like to unsubscribe from the Notification List for this product you will find details of how to do so in the e-mail that has just been sent to you!