Parts are optimized to print on a Makerbot Replicator 2 and sliced with Makerware. Download the parts from thingiverse and print them out using the recommended settings below.
Ray Gun
This model is composed of 10 pieces that snap-fit together. Each piece should be printed separately in your favorite colored PLA. The diffuser should be printed in transparent PLA to soften the NeoPixel ring.
This model is composed of 10 pieces that snap-fit together. Each piece should be printed separately in your favorite colored PLA. The diffuser should be printed in transparent PLA to soften the NeoPixel ring.
| raygun-diffuser.stl raygun-ring.stl raygun-sensor.stl raygun-neck.stl raygun-body.stl raygun-handle-top.stl raygun-handle-btm.stl raygun-handle-lid.stl raygun-cap.stl raygun-cone.stl |
PLA @230 %15 infill 2 shells 0.2 layer height 90/150 speeds |
12 hours? Like a day! Yes, it's for super crazy 3d printer operators. |
Light Handle
Easier to print and assemble, the light handle model is composed of only 4 pieces that snap-fit together.
Easier to print and assemble, the light handle model is composed of only 4 pieces that snap-fit together.
| flir-handle-btm.stl flir-handle-top.stl flir-handle-light.stl flir-handle-diffuser.stl |
PLA @230 %15 infill 2 shells 0.2 layer height 90/150 speeds |
4-5 hours depending on how soon you switch out the parts! |
Page last edited April 09, 2014
Text editor powered by tinymce.
