Pour 1st Layer

Add a small amount of resin, just enough to fill the bottom of the mold. Gently slosh the resin around the mold so it is evenly distributed.

Place the mold on a tray to keep the resin level.

 

Pop Bubbles

Use a tool to carefully remove any bubbles in the resin.

 

Cure 1st Layer

Align the tray and mold inside the UV lamp.

 

Allow the resin to cure for about three minutes.

Prep Layer 2

Place glitter or small objects around the center of the mold.

 

Objects 

Some objects may need to be inserted at an angle to help the air bubbles escape.

 

Glitter

Only use a small amount of glitter to avoid blocking UV light while curing.

 

Pour enough resin to fill over the top of the object in the mold and allow to cure for another 3 minutes.

Layer 3

The 3rd and last layer can act as a backdrop for the keycap.

Add more resin on top.

Glitter or pigment can give the keycap a pop of color when diffused.

Mix and stir it up nicely so the pigment blends into the resin.

Fill the mold to the top and remove any bubbles that form. 

Stem

Hold the stem mold at an angle and apply a very small amount of resin to one side of the stem. Allow the resin to slowly seep into the mold.

Wait for the resin to fully seep into the mold before applying another small drop of resin. This will force any air out of the  the stem mold.

Continue until the stem mold is full with no air bubbles.

 

Align Stem Mold

Be careful and precise with your placement so the two mold are properly aligned.

Allow the resin to overfill, it’s a good sign you have used enough resin. If it’s not overfilling you might not have enough.

Back into the UV lamp, you want to give each side 5 minutes  to cure both sides.

 

If cutting off any resin after it fully cures, please wear eye protection.

Pull Mold

Allow the mold to cool down. 

Carefully pull out our keycap.

Any excess resin, or molding flash, will need to be removed and can be trimmed away.

We used our flush snips, just be sure to angle it down when cutting so the flash doesn’t fly across the room.

You’ll find the surface is a bit tacky so you can use some isopropyl alcohol to remove some of the stickiness.

If they still feel a bit sticky, you could also let them sit in direct sunlight for a few minutes.

 

And there you have it! Resin casted keycaps are really fun and definitely approachable.

We hope this inspires you to try out resin casting and hope this helps you learn the techniques with some of our tips and tricks.

So what ideas do you have for keycaps? Be sure to share your projects with us on Adafruit’s Weekly Show and Tell!

Eye

This guide was first published on Aug 10, 2021. It was last updated on Mar 08, 2024.

This page (Make Keycap Molds) was last updated on Mar 08, 2024.

Text editor powered by tinymce.