Wiring the switch is simple. All you have to do is solder wires to any two taps on the switch and then solder the other two ends to the through holes in the power backpack (the same holes you cut the trace between before). I also added a little bit of heat shrink tubing to the wires on the switch end to keep anything from shorting out.
OUT OF STOCK NOTIFICATION
You have been successfully subscribed to the Notification List for this product and will therefore receive an e-mail from us when it is back in stock!
For security reasons, an e-mail has been sent to you acknowledging your subscription. Please remember that this subscription will not result in you receiving any e-mail from us about anything other than the restocking of this item.
If, for any reason, you would like to unsubscribe from the Notification List for this product you will find details of how to do so in the e-mail that has just been sent to you!