Tuck the LED holder up into the cavity in the silicone line it up for snapping the cap onto the base. Angle the cap to get the snaps on one side aligned and then press down to let the other set slide home. If you don't feel a click, it might be because some material slumped on the overhangs of the cap while it was printing. You can adjust this with a small file or emery board.
OUT OF STOCK NOTIFICATION
You have been successfully subscribed to the Notification List for this product and will therefore receive an e-mail from us when it is back in stock!
For security reasons, an e-mail has been sent to you acknowledging your subscription. Please remember that this subscription will not result in you receiving any e-mail from us about anything other than the restocking of this item.
If, for any reason, you would like to unsubscribe from the Notification List for this product you will find details of how to do so in the e-mail that has just been sent to you!