Attach the CPX (Circuit Playground Express) to the Crickit following this guide.

  • Attach an alligator clip to capacitive touch input A3 on the CPX.
  • Plug the servo into input 1 on the servo section on CRICKIT. Orient the leads such that the yellow wire is on the outside edge of CRICKIT.
  • For power use a 5V 2A (2000mA) switching power supply plugged into the 5V DC jack. When you want the project to run, please be sure the tiny on/off switch next to the CRICKIT's DC jack is on.

This guide was first published on Dec 07, 2018. It was last updated on Dec 07, 2018.

This page (Wiring Electronics) was last updated on Dec 06, 2018.

Text editor powered by tinymce.