Circuit
Wire Prep
Prep four jumper wires with Dupont socket connectors (one each red, black, blue, yellow) by snipping off one end and then stripping about 1/2" of insulation.
Heat Shrink Tubing
Slide three lengths of heat shrink tubing over the four-wire jumper cable bundle. The tubing near the DuPont connectors should be just wide enough to fit over all four ends. (See photos below)
Connect to Encoder
Loosen the four screws in the main row of the encoder, then hook each wire over it's screw. Use a Philips screwdriver to tighten them, making sure stray strands are not shorting any positions.
- A = Yellow
- B = Blue
- 0V = Black
- Vcc = Red
Slide one piece of the heat shrink tubing up and heat it to, you know, shrink it.
Slide two sections of heat shrink tubing over the four Dupont pin connector cables.
Join Cables
Connect each Dupont pin connector to it's associated, same-color socket connector on the encoder cable (these photos show the 3D printed case we'll create on the next page).
Secure the connection with heat shrink tubing or electrical tape.
The encoder cable is now ready to be fit into a 3D printed enclosure and used on the Fruit Jam.
Page last edited October 19, 2026