Bring a little bit of Times Square into your home with this 16 x 32 RGB LED matrix panel. These panels are normally used to make video walls, here in New York we see them on the sides of busses and bus stops, to display animations or short video clips. We thought they looked really cool so we...

Have you ever tried making a connection from your Raspberry Pi to a breadboard and had trouble finding the pin you need because nothing is labelled? Have you made mistakes matching a diagram of the pinout to the actual pins? Are you not making enough connections to use our amazing

Connecting wires to the Raspberry Pi GPIO? The Pi GPIO reference board from Low Voltage Labs provides an easy way to make sure you are hooking up the wires correctly.Features:Only 0.8mm thick.Compatible with Raspberry Pi Rev 1 and Rev 2 GPIO.Idiot proof,...

Level shifting chips let you connect 3V and 5V devices together safely. This chip is similar to others in the shop (such as the 74LVC125) except this one is particularly good at converting 3V logic up to 5V. This is in demand, especially when connecting some 3V devices such as...

This is an FCC/CE certified and UL listed power supply. Need a lot of 5V power? This switching supply gives a clean regulated 5V output at up to 2000mA. 110 or 240 input, so it works in any country. The plugs are "US 2-prong" style so you may need a plug adapter, but you can pick one...

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires approximately 6" (150mm) long and come in a 'strip' of 40 (4 pieces of each of ten colors). They have 0.1" sockets on either end and fit cleanly next to each other on...

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 6" (150mm) long and come in a 'strip' of 40 (4 pieces of each of ten rainbow colors). They have 0.1" male header contacts on either end and fit cleanly next to each other...

If you need to connect a DC power wall wart to a board that doesn't have a DC jack - this adapter will come in very handy! There is a 2.1mm DC jack on one end, and a screw terminal block on the other. The terminals are labeled with positive/negative assuming a positive-tip configuration...