Clue And MagTag Pep Talk Generator

CircuitPython is a derivative of MicroPython designed to simplify experimentation and education on low-cost microcontrollers. It makes it easier than ever to get prototyping by requiring no upfront desktop software downloads. Simply copy and edit files on the CIRCUITPY flash drive to iterate.

The following instructions will show you how to install CircuitPython. If you've already installed CircuitPython but are looking to update it or reinstall it, the same steps work for that as well!

Set up CircuitPython Quick Start!

Follow this quick step-by-step for super-fast Python power :)

Download the latest version of CircuitPython for CLUE from circuitpython.org

	Click the link above to download the latest version of CircuitPython for the CLUE. Download and save it to your desktop (or wherever is handy).
	Plug your CLUE into your computer using a known-good USB cable. A lot of people end up using charge-only USB cables and it is very frustrating! So make sure you have a USB cable you know is good for data sync. Double-click the Reset button on the top (magenta arrow) on your board, and you will see the NeoPixel RGB LED (green arrow) turn green. If it turns red, check the USB cable, try another USB port, etc. Note: The little red LED next to the USB connector will pulse red. That's ok! If double-clicking doesn't work the first time, try again. Sometimes it can take a few tries to get the rhythm right!
	You will see a new disk drive appear called CLUEBOOT. Drag the adafruit-circuitpython-clue-etc.uf2 file to CLUEBOOT.
	The LED will flash. Then, the CLUEBOOT drive will disappear and a new disk drive called CIRCUITPY will appear. If this is the first time you're installing CircuitPython or you're doing a completely fresh install after erasing the filesystem, you will have two files - boot_out.txt, and code.py, and one folder - lib on your CIRCUITPY drive. If CircuitPython was already installed, the files present before reloading CircuitPython should still be present on your CIRCUITPY drive. Loading CircuitPython will not create new files if there was already a CircuitPython filesystem present. That's it, you're done! :)