The Arduino Nano RP2040 Connect is the first board from Arduino featuring the RP2040 microcontroller. It's in the Arduino Nano form factor and has WIFI capabilities, making it a great choice for IoT projects.

Additionally, it has 16MB of flash, onboard sensors and multiple digital and analog I/O pins. The best part: it runs CircuitPython! This guide will show you how to get started with CircuitPython on the Arduino Nano RP2040 Connect.

(BLE via the radio module is available via Arduino, but is not currently supported in CircuitPython.)

Parts

1 x Arduino Nano RP2040 Connect
Arduino Nano RP2040 Connect
Fully Reversible Pink/Purple USB A to micro B Cable
This cable is not only super-fashionable, with a woven pink and purple Blinka-like pattern, it's also fully reversible! That's right, you will save seconds a day by...
$3.95
In Stock
Angled shot of half-size solderless breadboard with red and black power lines.
This is a cute, half-size breadboard with 400 tie points, good for small projects. It's 3.25" x 2.2" / 8.3cm x 5.5cm with a standard double-strip in the...
$4.95
In Stock
Angled shot of 10 12mm square tactile switch buttons.
Medium-sized clicky momentary switches are standard input "buttons" on electronic projects. These work best in a PCB but
$2.50
In Stock
scattered pile of multi colored unlit LEDs
Need some indicators? We are big fans of these diffused LEDs. They are fairly bright, so they can be seen in daytime, and from any angle. They go easily into a breadboard and will add...
$4.95
In Stock
Angled shot of 25 Through-Hole Resistors - 220 ohm 5% 1/4W.
ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of...
$0.75
In Stock

This guide was first published on Jun 04, 2021. It was last updated on Mar 28, 2024.

This page (Overview) was last updated on Mar 08, 2024.

Text editor powered by tinymce.