Install Side T-NutsInsert two T-Nuts to both of the sides of the two aluminum extrusion bars. Make sure to follow the orientation of the T-Nuts and reference the photo. |
|
Install Bearing MountGrab the bearing mount assembly and slide the T-Shaped nubs through the slotted aluminum extrusions. This should be installed to the opposite side of the tripod mount. The bearing mount assembly should be able to freely slide through the slotted aluminum extrusion. |
|
Insert Side ScrewsSlide the bearing mount assembly so the mounting holes line up with the T-Nuts. Insert and fasten M4 screws to secure the mount to the T-Nuts. Leave them loose – The assembly need to be able to slide along the t-slotted aluminum extrusions. |
|
Install Bearing Bar MountGrab the bearing bar mount and fit it onto the end cap of the two aluminum extrusions. The bar mount features t-shaped nubs that should slot into the aluminum extrusions. |
|
Secure Bar MountSlide the remaining T-Nut so it's line up with the mounting hole in the bar mount. Insert and fasten M4 screws to fix the bar mount to the T-Nuts. Again, you'll want to leave them a bit loose so we can adjust them later in the build. |
|
More T-NutsInsert two more T-Nuts on to the other side of the aluminum extrusions. These will secure the Motor Mount assembly to the extrusion bars. Again, make sure the orientation matches the photo. |
|
Install Motor Mount AssemblyInsert and slide the motor mount assembly onto the two slotted aluminum extrusions. Both the rail mount and the support mount should be able to fitted and slide along the slotted aluminum extrusion bars. |
Extrusion Assembly
This guide was first published on Dec 18, 2019. It was last updated on Dec 18, 2019.
This page (Extrusion Assembly) was last updated on Apr 11, 2021.
Text editor powered by tinymce.