Feather Wiring

by Ruiz Brothers

Wiring BLE Feather

Next we’ll wire up the Adafruit Feather. I used a stick vise to secure the PCB while soldering wires.

Solder JST Cable

We’ll solder the JST cable female to ground, voltage and any of the available data pins. In this project, the code is set to Pin #6. If you decide to change this, you will need to reflect that in the code.

Wired BLE Feather

Now the feather just needs a way to turn the circuit on and off.

Connect JST to BLE Feather

Plug in the male JST connector into the female JST connector on the Feather. Make sure the registration keys are lined up, it should snap fit!
WIRE NEOPIXEL STRIP Switch Wiring
This guide was first published on Aug 13, 2019. It was last updated on Aug 13, 2019. This page (Feather Wiring) was last updated on Aug 27, 2019.