Angled shot of a Adafruit Feather nRF52840 Express.
The Adafruit Feather nRF52840 Express is the new Feather family member with Bluetooth Low Energy and native USB support featuring the nRF52840!  It's...
Out of Stock
Mini Push-Pull Solenoid wired to Trinket, activating back and forth
Solenoids are basically electromagnets: they are made of a coil of copper wire with an armature (a slug of metal) in the middle. When the coil is energized, the slug is pulled into the...
$4.95
In Stock
Slim Lithium Ion Polymer Battery 3.7v 400mAh with JST 2-PH connector and short cable
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
Out of Stock
N-channel power MOSFET in TO-220 package
When you need to switch a lot of power, N-channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 packages so they fit nicely into any breadboard or...
$2.25
In Stock
Top view of Adafruit Perma-Proto Half-sized Breadboard PCB.
Customers have asked us to carry basic perf-board, but we never liked the look of most basic perf: it's always crummy quality, with pads that flake off and no labeling. Then we...
$4.50
In Stock
pack of five, 36-pin 0.1 inch Female header
Female header is like the duct tape of electronics. Its great for connecting things together, soldering to perf-boards, sockets for wires or break-away header, etc. We go through these...
$2.95
In Stock
Angled shot of 25 Through-Hole Resistors - 10K ohm 5% 1/4W.
ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of 10K...
$0.75
In Stock
 10 pack of 1N4001 Diodes
This here is a 10 pack of the classic 1N4001 power blocking diode. These are good for reverse polarity protection (put it between your DC power jack and circuitry to avoid a...
$1.50
In Stock
Breadboard-friendly SPDT Slide Switch
These nice switches are perfect for use with breadboard and perfboard projects. They have 0.1" spacing and snap in nicely into a solderless breadboard. They're easy to switch...
$0.95
In Stock