Build the Glove Controller! (Pt. 2)

Save Subscribe

Use an alligator clip or insulated wire to connect the CPX ground ("GND") to the thumb pad.

Stitch conductive thread from the CPX capacitive touch pads (A1, A2, A3 & A4) to each of the four fingers.

Stitch conductive thread from the CPX capacitive touch pads (A1, A2, A3 & A4) to each of the four fingers.

If you have a multimeter, check continuity between the CPX pins and the conductive thread pads.

 Build the Glove Controller! (Pt. 1) Plan out your Controller! 

This guide was first published on Feb 19, 2018. It was last updated on Feb 19, 2018.

This page (Build the Glove Controller! (Pt. 2)) was last updated on Jun 29, 2022.

Text editor powered by tinymce.