This is a remix of the 3d Printed Circuit Playground Yo Yo project by the Ruiz Brothers.  

There are 4 different pieces to print:  the base, the top, the buttons, and the cover which holds the fiber optics or light pipe.

If you don't have access to a 3d printer, you can order the whole case ready-to-go from Shapeways.

Slice Settings

Below are some recommended slice settings. These parts were printed on an Up! Mini.

  • .15mm layer height
  • 220C extruder / PrintInZ Skin
  • 20% infill
  • 4 top/bottom layers
  • 2 shells / parameters
  • 40mm/s printing speed

This guide was first published on Feb 21, 2017. It was last updated on Feb 21, 2017.

This page (3d Printing) was last updated on Feb 19, 2017.

Text editor powered by tinymce.