Assembly

Secure Metal Pieces

The base part has cut notches on the lip. The triangle shape should be able to fit in the notches. Use a piece of double-sided Scotch tape to secure the aluminum triangle piece onto the brass base.

Attach Mount to Circuit Playground Board

Place the 3D printed mount over the top of the Circuit Playground board - the notch cutout should be over the JST connector. Press the standoffs down so the pegs are fitted into the holes on the board.

Attach Mount to Combadge

Add a strip of double-sided tape to the back of the combadge. Then, secure it to the back front of the Circuit Playground mounting place. Firmly press the two together to secure them in place.

Connect Battery

Plugin the male JST connector from the 100mAh lipo battery into the female JST connector on the Circuit Playground board.

Secure Metal Backing

Add some strips of double-sided tape to the surface of the 3D printed metal backing, then stick it onto the back of the Circuit Playground board.

Mount Battery

Use a piece of double-sided tape or mounting putty/tack to the back of the battery and stick it on the back of the Circuit Playground board.

Add to Shirt!

Now you can add place the neodymium magnet underneath your shirt and place the combadge over it! 

This guide was first published on Aug 24, 2016. It was last updated on Aug 24, 2016. This page (Assembly) was last updated on Mar 26, 2019.