On one end of your ribbon you'll connect pads marked 3V, SCL, SDA, and GND on FLORA to corresponding pads on the color sensor.

Then you'll chain on 12 NeoPixels at even intervals along the ribbon, connecting pads marked + to VBATT on FLORA, likewise the ground bus from FLORA's GND to every pixel pad marked -. Small segments of conductive thread connect each pixel's data pad to the next.

This guide was first published on May 22, 2013. It was last updated on May 22, 2013.

This page (Layout & Circuit Diagram) was last updated on May 22, 2013.

Text editor powered by tinymce.