Bring a little bit of Times Square into your home with this sweet 64 x 32 square RGB LED matrix panel. These panels are normally used to make video walls, here in New York we see them on the sides of busses and bus stops, to display animations or short video clips. We thought they looked...

 nice whoppin' rectangular slab of some lovely black acrylic to add some extra diffusion to your LED Matrix project. This material is 2.6mm (0.1") thick and is made of special cast acrylic that makes it perfect for glowy projects, especially matrices or NeoPixels.Unlike...

Our all-in-one 5V 2.5 Amp + MicroUSB cable power adapter is the perfect choice for powering single-board computers like Raspberry Pi, BeagleBone, or anything else that's power-hungry!This adapter was specifically designed to provide 5.25V, not 5V, but we still call it a 5V USB...

As technology changes and adapts, so does Adafruit, and speaking of adapting, this adapter has a Micro B USB jack and a USB C plug.USB C is the latest industry-standard connector for transmitting data and power....

This here is your standard A to micro-B USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your Metro, Feather, Raspberry Pi or other dev-board or microcontrollerApproximately 3 feet / 1 meter long

This high-torque standard servo can rotate approximately 180 degrees (90 in each direction). You can use any servo code, hardware, or library to control these servos. Good for beginners who want to make stuff move without building a motor controller with feedback & gearbox. Comes with 3...

Socket (female) header is like the duct tape of electronics. Its great for connecting things together, soldering to perf-boards or PCBs to allow 22AWG wire or male header to connect, etc. We go through these gals real fast, and thought that given how handy they are, we'd offer them in a pack of...

Breakaway header is like the duct tape of electronics, and this header is one better with extra long pins on both sides. This makes it great for connecting things together that have two sockets - especially solderless breadboards. We also...

As technology changes and adapts, so does Adafruit, and speaking of adapting, this right angle adapter is USB C socket-to-plug.USB C is the latest industry-standard connector for transmitting...

Are you still looking for that perfect PCB holder? The low profile PCB Stickvise might be just the thing you need!In performing the simple task of holding a PCB near table level, the Stickvise is great because your hands can rest directly on the...

Stickvise PartLift holds thru-hole parts in place to free up your hands while you solder the legs. A simple yet useful tool to go along with your Stickvise or other PCB holder. It solves the annoying problem of soldering thru-hole parts that can slide down the PCB when its...