Attach Feather to Glove

Lay the Feather onto the back of the glove and drive an awl or a small screwdriver through the rubber padding to create a hole corresponding to each Feather mounting hole.

Drive an M2.5 x 10mm screw up from inside the glove as shown for each of the holes. (I skipped the fourth hole due to space constraints with the screw terminal block, but three hold it just fine.)

Affix a nut and 6mm F-F hex standoff to each screw.

Use M2.5 x 4mm screws to attach the Feather to the standoffs.

Sensor Positioning and Cabling

Dry fit the sensor position to find a good mounting point and cable run path.

With this particular glove it worked out well to remove a few stitches from the palm patch and run the STEMMA QT cable through it.

Sew the Sensor

Plug the STEMMA QT cable into the board.

Use a needle and thread to sew the sensor board into place on the finger tip.

Mount the Speaker

You can mount the speaker using a similar technique to the Feather.

Connect Battery

Nothing too fancy here! Use a hair band or other wrap to secure the battery under the Feather and then plug it in as shown.