Little clicky switches are standard input "buttons" on electronic projects. These work best in a PCB but can be used on a solderless breadboard as shown in this tutorial. The pins are normally open (disconnected) and...

This is a 'full-size' premium quality breadboard, 830 tie points. Good for small and medium projects. It's 2.2" x 7" (5.5 cm x 17 cm) with a standard double-strip in the middle and two power rails on both sides. You can pull the power rails off easily to make the...

Customers have asked us to carry basic perf-board, but we never liked the look of most basic perf: it's always crummy quality, with pads that flake off and no labeling. Then we thought about how people actually prototype - usually starting with a solderless breadboard and...

Pipe audio in or out of your project with this very handy breadboard-friendly audio jack. It's a stereo jack with disconnect-switches on Left and Right channels as well as a center ground pin. You can use any 3.5mm stereo cable with this jack. The pins are on 0.1" spacing so it plugs...

Perfect for bread-boarding, free wiring, etc. This box contains 6 spools of solid-core wire. These spools of solid-core wires are easily soldered to, keeps its shape pretty well when bent and is rated 80C and 300V (UL AWM style 1007). We...

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of 220Ω Resistors. More specifically, they are carbon film, through-hole...

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of 1.0KΩ Resistors. More specifically, they are carbon film, through-hole...

If you've got a lot of wire-stripping to do, you may want to try out an automatic stripper/cutter! They are fantastic for stripping and cutting stranded and solid-core 24 or thicker AWG wires and ribbon cables. The tool has both metric (up to ~20mm) and imperial (up to 0.75")...